3 canvas(es) — paginate below the viewer, or use the Canvases tab on the right.
Scope of Use of Rivets and Electric Welding in Hull Sections of Destroyers and Torpedo Boats, Shipbuilding Section, Works Department, Maizuru Naval Port Department, 10.12.24
- AI summary (β)
- Technical materials prepared on December 24, Shōwa 10, by the Shipbuilding Section, Works Department, Maizuru Naval Port Department, defining the scope of use of rivets and electric welding in hull sections of destroyers and torpedo boats. They indicate a policy of avoiding overhead welding and on-site flat-position welding, addressing the treatment of major parts such as the upper deck, shell plating, double bottom, and bilge keel, and using rivets for parts subject to repeated stress, while listing locations where welding is to be applied, such as deck girders, longitudinals, stringers, bulkheads, and deckhouses. They also record experimental methods for distortion and residual internal stress through the Kure large-scale tests. Keywords: destroyers, torpedo boats, Shipbuilding Section, Works Department, Maizuru Naval Port Department, electric welding, rivets, hull structure, distortion, Kure large-scale testsAuto-generated by Azure OpenAI gpt-5.5 from OCR text (which may contain errors) and image captions.
- Item ID
- fc21b19d-783a-472d-ac26-24656e6e82b4
- Catalogue ID
- 30120401
- Card catalogue
- "Minutes of the Meeting of Planning Supervisors Concerning Electric Welding," etc.
- Category
- 軍艦構造:溶接
- Holder
- 東京大学柏図書館
- Year registered
- 2007
- GCV entities
- Diagram


































